Submit Manuscript  

Article Details


Research on High-speed Cutting of Cr12MoV Hardened Steel - A Review

Author(s):

Fei Sun*, Guohe Li, Qi Zhang and Meng Liu   Pages 1 - 12 ( 12 )

Abstract:


Cr12MoV hardened steel is widely used in the manufacturing of stamping die because of its high strength, high hardness, and good wear resistance. As a kind of mainstream cutting technology, high-speed machining has been applied in the machining of Cr12MoV hardened steel. Based on the review of a large number of literature, the development of high-speed machining of Cr12MoV hardened steel was summarized, including the research status of the saw-tooth chip, cutting force, cutting temperature, tool wear, machined surface quality, and parameters optimization. The problems that exist in the current research were discussed and the directions of future research were pointed out. It can promote the development of high-speed machining of Cr12MoV hardened steel.

Keywords:

Cr12MoV hardened steel, high-speed machining, machining mechanism, tool wear, surface quality, parameter optimization

Affiliation:

Mechanical Department, Tianjin University of Technology and Education, Tianjin, 300222, Mechanical Department, Tianjin University of Technology and Education, Tianjin, 300222, Mechanical Department, Tianjin University of Technology and Education, Tianjin, 300222, Institute of Mechanical Engineering, Dalian University of Technology, Dalian, 116024



Read Full-Text article